Difference between revisions of "Audio capture"

Revision as of 17:32, 20 July 2017

You can record audio from any recording or playback device or both. This includes microphone input or output of the speakers. Select an audio device by the Primary Audio or the Secondary Audio button in the Main View.

Figure 1: Playback (Primary) devices

Figure 1: Recording (Secondary) devices

To enable recording a playback device (e.g. Speakers):

1. In the main view, click the Primary Audio button to open the selection menu.
2. Select an audio device from the selection menu.
3. Click the Record button to start recording.

To enable recording a recording device (e.g. Microphone):

1. In the main view, click the Secondary Audio button to open the selection menu.
2. Select an audio device from the selection menu.
3. Click the Record button to start recording.

Notes

• List of input devices may vary depending on your hardware.
• To disable audio recording, select <none> from the selection menu.
• You may change the bit-rate, sample-rate or number of channels of the output stream from Audio Settings.

Supported formats

Screenbits supports recording the following audio formats:

• 44100hz 16bits mono
• 44100hz 16bits stereo
• 48000hz 16bits mono
• 48000hz 16bits stereo
• 96000hz 16bits mono
• 96000hz 16bits stereo
• 196000hz 16bits mono
• 196000hz 16bits stereo

If you attempt to record an audio device with an unsupported format, an error message pops up asking you to select a different format for the device.

To change the default format of an audio device:

1. Select Settings from the Recording menu to open Settings view.
2. From the Audio section under the Audio & Video tab, click Configure to open Sound settings.
3. Right click on the name of the device in list under the Playback or Recording tab and click Properties.
4. From the Default Format section under the Advanced Tab select one of the supported formats above.
5. Click OK to apply changes to the device properties

Figure 2: Audio Format - Sound settings